CAS:	7789-75-5
MF:	CaF2
MW:	78.07
EINECS:	232-188-7
Product Categories:	Inorganics;metal halide
Mol File:	7789-75-5.mol

Chemical Properties	Calcium fluoride is the main ingredient of fluorspar or fluorite, the chemical formula is CaF2, it is colorless cubic crystal or white powder. The relative density is 3.18, the melting point is 1423℃, boiling point is about 2500 ℃. The solubility in water is minimal , 100g water can dissolve only 0.0016g at 18 ℃, it is insoluble in acetone, but soluble in hydrochloric acid, hydrofluoric acid, sulfuric acid, nitric acid and ammonium salt solution, and it can not react with dilute acid, but can react with hot concentrated sulfuric acid and generate hydrofluoric acid, it can form a complex when dissolves in aluminum and iron salts (Fe3 +) solution. Natural calcium fluoride is mineral fluorite or fluorspar, often shows gray, yellow, green, purple and other colors, sometimes it is colorless, transparent, shiny glass, brittle, and the relative density is 3.01~3.25, it has significant phenomenon of fluorescence. It can be used as the source of fluorine and the material to make hydrofluoric acid system, fluoride; and it can also be used in terms of the manufacture of glass, enamel, glaze. Fluorite is mainly used as a flux in metallurgy, the very pure fluorspar can be used to make specialty lenses. Water when contains (1~1.5) × 10-6 calcium fluoride can prevent dental problems. In addition, it can be used in smelting iron and steel, chemicals, glass, ceramics manufacturing. Pure product can be used for catalyst of dehydration, dehydrogenation. By the effect of soluble calcium salts (calcium carbonate or calcium hydroxide) and sodium fluoride or hydrofluoric acid, ammonium fluoride, calcium fluoride can be obtained.
crystal structure	Calcium fluoride is an ionic crystal with the fluorine anions in a simple cubic array and calcium cations in half of the cubic sites of the structure. The calcium ions can also be thought of as being on an "expanded" fcc lattice with the fluorine ions causing their lattice separation to be 0.39 nm. This representation is shown in the lower diagram. The unit cell has 4 Ca2+ ions and 8 F1- ions. The material is transparent in the visible spectral region, and shows electronic optical adsorption in the ultra violet and lattice optical absorption in the infrared.
Uses	Industry Application Role/benefit Chemical manufacture Production of hydrofluoric acid and fluoride Raw material/source of fluoride Production of fluorine fine chemicals and synthetic cryolite Raw material/source of fluoride Architectural material Production of glass Fluxing agent/promote the melting of raw materials Production of cement Mineralization agent Production of ceramic glaze Fluxes and coloring aids Metallurgy Iron and steel smelting, ferroalloy production,etc. Fluxing agent/reduce the melting point of refractory substances Medicine Treatment, control, prevention, & improvement of allergic reactions Promoting new bone formation Thermal imaging systems, spectroscopy, telescopes and excimer lasers Manufacture of optical components, such as windows and lenses Raw material/broad range of transmission light frequencies; low refractive index; high thermo stability Others Production of welding agents Important components in coatings of welding rods and welding powders Dehydration and dehydrogenation reaction Catalyst/accelerate the process of reaction Manufacture of brake lining Additive/helps reduce abrasion caused by high heat and friction
Production method	The fluorite deposits which have been found in china, are main used the mine using underground mining method, or shallow open-pit mining, and underground deep mining, for ore body most tilt vein, the extending is also large. Mining method is based in shallow hole Shrinkage Method based. Mining process sees "phosphate rock." Beneficiation methods have two types generally, the one is raw ore can become qualified ore concentrate by handling select, the second is hand-selected lean ore and tailings.
Chemical Properties	Calcium fluoride, CaF2, also known as fluorite and feldspar, is a colorless solid composed of cubic crystals. It has a low water solubility, but is readily soluble in ammonium salt solutions. Calcium fluoride is used in the synthesis of hydrofluoric acid and in etching glass. Calcium Fluoride is not hygroscopic and is relatively inert. It has a sufficiently high resistance to thermal and mechanical shock, and it is easily fabricated into a variety of detector geometries. Calcium Fluoride has a very low vapor pressure, allowing it to be used in a wide variety of vacuum applications. It is insoluble in water and most organic solvents, permitting radioactive samples in solution to be placed in direct contact with the crystal. Calcium Fluoride is a transparent material used for detecting γ-rays up to several hundred keV and for detecting charged particles. Because of its low atomic number, the material’s photofraction is relatively small which limits its use in γ-ray spectrometry at higher energies. However, the low atomic number makes Calcium Fluoride an ideal material for the detection of β-particles because of the small amount of backscattering.
Physical properties	White cubic crystal or powder; refractive index 1.434; density 3.18 g/cm3; hardness 4 Mohs; melts at 1,418°C; vaporizes at 2,533°C; insoluble in water (16 mg/L at 20°C); Ksp 3.9x10-11; slightly soluble in dilute mineral acid; soluble in concentrated acids (with reaction).
Uses	Naturally occurring CaF2 is the principal source of hydrogenfluoride, a commodity chemicalusedto produce a wide range of materials. Fluoride is liberated from the mineral by the action of concentrated sulfuric acid: CaF2 (solid)＋H2SO4 (liq)→CaSO4 (solid)＋2HF (gas) CaF2 is used as an optical component because of its chemical stability under adverse conditions.Calcium fluoride is commonly used as a window material for both infrared and ultraviolet wavelengths, since it is transparent in these regions (about 0.15 to 9 mm) and exhibits an extremely low-refractive index. Calcium Fluoride is a water insoluble calcium source for use in oxygen-sensitive applications, such as metal production. In extremely low concentrations (ppm), fluoride compounds are used in health applications. Fluoride compounds also have significant uses in synthetic organic chemistry. They are also commonly used to alloy metal and for optical deposition. It is also used as a flux for melting and liquid processing of iron, steel and their composites. Its action is based on its similar melting point to iron, on its ability to dissolve oxides and on its ability to wet oxides and metals.
Uses	Fluorspar is the main primary source of fluorine and its Compounds. In ferrous metallurgy it is used as a flux to increase the fluidity of the slag. The steel industry is the largest consumer; the chemical industry, second and glass and ceramics, third. Synthetic fluorspar is used in the optical industry (transmits u.v. rays), and pure calcium fluoride is used as catalyst in dehydration and dehydrogenations. Used to fluoridate drinking water.
Uses	Calcium fluoride is the commercially important source for fluoride compounds as well as hydrogen fluoride. It is transparent from ultraviolet to infrared region. It is used in spectroscopy, thermal imaging systems and excimer lasers; it is also used in the manufacturing of optical components including windows, prisms and lenses. In addition, it is also used in aluminum-metallurgy, brake lining manufacturing industries, and in tooth enamel.
Definition	A pure naturally occurring form of calcium fluoride.
Production Methods	The commercial product is obtained from naturally occurring mineral fluorspar, which is purified and powdered. Also, it may be precipitated by mixing a solution of sodium fluoride with a soluble calcium salt: Ca(NO3)2 + 2NaF → CaF2 + NaNO3 Alternatively, it may be obtained by treating calcium carbonate with hydrofluoric acid：CaCO3 + 2HF → CaF2 + CO2 + H2O.
Definition	A mineral form of calcium fluoride (CaF2), used in making some cements and types of glass.

Packing &shipping&Payment

Company information
Hebei Mojin Biotechnology Co., Ltd, Our company is a professional in 4'-Methylacetophenone,Levamisole hydrochloride ,N-Methylformamide and other chemical reagents research and development production enterprises. Our business covers more than 30 countries, most of the big customers come from Europe, America and other countries in the world, we can guarantee the quality and price. In recent decades, with the efforts of all employees, we have established many cooperative companies in shandong, henan, guangdong and other places. Our corporate purpose is based on the market, enhance the strength, take the road of scientific and environmental sustainable development, relying on the country. Technology r & d center, increase the investment in r & d, based on the domestic market, expand the international market, manufacturing quality products, sincere service to the society, into a modern, ecological, scientific and technological enterprise world.

Advantage
In stock